@github-actions[bot] commented on GitHub (Nov 27, 2023):
This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs.…
@github-actions[bot] commented on GitHub (Nov 29, 2023):
This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs.…
@sebastian-tischer commented on GitHub (Oct 28, 2023):
Ah got it 🤣 So all boils down again to my hardware to slow right? 🤣
@NickM-27 commented on GitHub (Oct 27, 2023):
min is the minimum value, so if min is 1.0 then that mean any object that is taller than it is wide (so having a ratio < 1) would be immediately…
@NickM-27 commented on GitHub (Oct 27, 2023):
the ratio is the width in pixels of the bounding box divided by the height. So a ratio of 1 would be a square, 0.5 would be a tall skinny box and 2…
@FigJam23 commented on GitHub (Oct 27, 2023):
Thank you for the explanation I'm definitely Look forward to v13 yay. I'm still a little confused between min and max options if I set min to 1 =…
@NickM-27 commented on GitHub (Oct 28, 2023):
The decoder is falling behind which means the camera is currently sending data for 12:10 PM and that's what recordings are looking at but the…
@awwbaker commented on GitHub (Oct 27, 2023):
I went through and double checked two space indents (I missed this in the "Getting Started Section." I will paste my working file below if it perhaps…
@sebastian-tischer commented on GitHub (Oct 28, 2023):
Thanks @NickM-27 for your fast reply - as always 👍 What I don't understand, is that the decoder is behind - the image around the…
@NickM-27 commented on GitHub (Oct 27, 2023):
this is usually due to the decoder lagging behind, so the frame is processed after the object was actually there which then means that the recordings…
@FigJam23 commented on GitHub (Oct 27, 2023):
I'm unsure if this is a good starting point I'm assuming we should be using a 16/9 aspect ratio for this if this is the case my thoughts of a test…
@NickM-27 commented on GitHub (Oct 27, 2023):
your indentation is inconsistent, spacing should always be done in increments of 2 spaces, but some parts of your config only have 1 space
@GregHilston commented on GitHub (Oct 28, 2023):
I ended up getting this working in a Proxmox LXC, which can now see my coral USB. i wish I could have gotten it working in my original Debian VM,…