@NickM-27 commented on GitHub (Nov 5, 2023):
enable trace logs and see what the error is
@blakeblackshear commented on GitHub (Nov 5, 2023):
The next steps would be to back down frigate to a bare minimum config and slowly add parts back until you can see what is causing the issue.
@NickM-27 commented on GitHub (Nov 5, 2023):
Most likely because the container was not rebuilt, so the new file wasn't used.
@NickM-27 commented on GitHub (Nov 5, 2023):
go2rtc does not support native UDP input, you must use ffmpeg: for udp only cameras
@NickM-27 commented on GitHub (Nov 5, 2023):
It sounds like you are trying to use the docker-compose file included in the repo which is only for development. If you are just trying to run frigate…
@madasus commented on GitHub (Nov 5, 2023):
nothing is shown on the console. I'll check to see if there is anything in syslog. The last time i checked there was nothing - the whole machine was…
@joseph2903106 commented on GitHub (Nov 5, 2023):
Thank you very much, I just don’t understand why the result of modifying nginx.conifg is still the same
@pathwayx99 commented on GitHub (Nov 5, 2023):
Hi Nick, thanks for you reply. You mean like this?
@NickM-27 commented on GitHub (Nov 5, 2023):
it can happen for many different reasons, if there is no information that can be provided then there's not really much that can be done on the frigate…
@NickM-27 commented on GitHub (Nov 5, 2023):
There's no info provided here so there is nothing to go off of. You first need to figure out why the machine is actually freezing (is it memory issue,…
@NickM-27 commented on GitHub (Nov 21, 2023):
These args seem weird in general, is there a reason to not just let it use the default args if everything is working?
@tdashmike commented on GitHub (Nov 21, 2023):
Well, there were a lot of stream errors and after googling, it seemed there were quite a few posts on adding similar args. It was also a rabbit hole…
@tdashmike commented on GitHub (Nov 24, 2023):
Well, it crashed again after I added everything back, going back to the config before expect I enabled recording this time. One thing I noticed is…
@github-actions[bot] commented on GitHub (Dec 25, 2023):
This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs.…