@baylanger commented on GitHub (Dec 30, 2023):
FYI just edited last comment to add a video.
Could it be the high-res video that makes the dot jumping around?
@MrSiO commented on GitHub (Dec 27, 2023):
Exactly, you have set the retention type as active objects and since there were no active objects in the time frame of the manual event, no recordings…
@btrudgill commented on GitHub (Dec 27, 2023):
go2RTC logs:
2023-12-27 20:11:52.742281010 [INFO] Preparing go2rtc config... 2023-12-27 20:11:54.155885108 [INFO] Starting go2rtc... 2023-12-2…
@NickM-27 commented on GitHub (Dec 27, 2023):
Exactly, you have set the retention type as active objects and since there were no active objects in the time frame of the manual event, no…
@NickM-27 commented on GitHub (Dec 27, 2023):
what are the go2rtc logs?
by the way, the duo 2 is a very problematic camera. I used to have one and many other users have had lots of problems as…
@baylanger commented on GitHub (Dec 30, 2023):
[EDIT] To be clear, the video below is done with "snap to edges" disable.
Right here, both are the latest version.
@MrSiO commented on GitHub (Dec 27, 2023):
This is covered in the docs, the recordings must still match the recording retention to be saved
https://deploy-preview-6262--frigate-docs.netli…
@btrudgill commented on GitHub (Dec 27, 2023):
Ok interestingly i have just spotted these logs, I haven't noticed them before?
@NickM-27 commented on GitHub (Dec 30, 2023):
What browser are you using? I've never had an issue freely moving a point of the mask
@NickM-27 commented on GitHub (Dec 27, 2023):
let frigate run with hwaccel and after 3 minutes paste the logs
@NickM-27 commented on GitHub (Dec 27, 2023):
This is covered in the docs, the recordings must still match the recording retention to be saved
https://deploy-preview-6262--frigate-docs.netlify.a…
@baylanger commented on GitHub (Dec 30, 2023):
Just tested with 0.13-beta7 - again getting the same behavior with the option enable or disable. It tries to snap all the time.
@NickM-27 commented on GitHub (Dec 29, 2023):
I see the problem, try this instead
@Alex12358795 commented on GitHub (Dec 29, 2023):
Wow! This fixed it and it works! Thank you so much!!