@fernandolcardoso commented on GitHub (Jun 27, 2025):
Hi, thank you for your thoughtful reply.
I completely understand your points and was already aware of some of the challenges you've…
@NickM-27 commented on GitHub (Jun 27, 2025):
The recommendation in this case would be to use the main stream, but change the detect resolution in frigate to 1280x720, so that the GPU can do the…
@broyuken commented on GitHub (Nov 19, 2025):
how would one do that? If I try to use the record stream from my Reolink elite floodlight as the detect stream, I get a ton of errors in the logs and…
@NickM-27 commented on GitHub (Jun 27, 2025):
Hi, thanks for the feature request. In general, using the high resolution stream is covered in the FAQs of these various features. During our…
@blakeblackshear commented on GitHub (Jun 27, 2025):
The snapshots are stored in the clips folder or you can use the APIs for this.
@NickM-27 commented on GitHub (Jul 16, 2025):
The recommended way to do this would be to create a saved search. You can use the search bar to set the search type to description and then star…
@nzkiwi68 commented on GitHub (Jun 26, 2025):
That worked!
Thanks so much.
Recreating the masks for the camera "entrance" fixed everything. It was the motion masks that were killing it.
@nzkiwi68 commented on GitHub (Jun 26, 2025):
Here's my latest config, with the detect bit here that I just cannot remove and save the config. I have removed it from the other cameras, backyard…
@NickM-27 commented on GitHub (Jun 26, 2025):
when I put that config into the config editor and remove the detect section I don't see any errors. I am not sure why there would be any problems…
@nzkiwi68 commented on GitHub (Jun 26, 2025):
All I did was remove the detect: section
Config Error:
@nzkiwi68 commented on GitHub (Jun 26, 2025):
@NickM-27 commented on GitHub (Jun 26, 2025):
it appears entrance is also the only camera to have absolute coordinate zones / masks. Maybe also delete those, and then re-create them in the UI so…
@nzkiwi68 commented on GitHub (Jun 26, 2025):
@nzkiwi68 commented on GitHub (Jun 26, 2025):
Following testing, here's what I have found:
I can remove detect: and width, height fps from everywhere in my config except from the entrance…